RECONDITIONED EI 10,000 6 STATION MAIL INSERTING MACHINE
STOCK REFERENCE NUMBER - EI10102508.
CHRONOLOGY - This model was 1st manufactured in 1986 by Bell + Howell. Since then most everything has been replaced by either new or reconditioned components, with the exception of main cast frame components. This reconditioning process took place in the month of September 2008, and is ready for shipment.
DESCRIPTION - A Bell & Howell EI10,000 (Phillipsburg style) 6 Station cabinet model, Maximum 10,000 cycles per hour rating, A312 Step Stage Turnover, two stage Chain Take Away, and 6 Foot Conveyor.
CONDITION - RECONDITIONED: All moving components that had noticeable wear was replaced. All surfaces have been powder coated. Blackened metal is redone in Black Zinc or Chrome Plating for rust and impervious wear protection. New chains and Stainless Steel shafts throughout. The drive motor and vacuum compressor has been reconditioned to new standards. Bearing assemblies and bronze bushings and been replaced and up graded to Oil light bushings or MDS Nylon bushings, A312 turnover Geneva gears replaced, all new electrical wiring, all electrical components have been replaced, and all electronic components have been replaced.
UPGRADED FEATURES - Power Front Table, Fault detection panel, digital LCD Counter, Circuit breaker panel, 4 tube upper sucker assembly, New style high volume vacuum pump, Optical Function control box, DC variable speed drive, clamp Insert hold-downs, new style Stainless Steel shuttle plate (wide brass trough), clamped Gripper arms, new style Insert rails, Nylon Insert chain track, ball bearing Hold down drive, new style Relay board (Omron relays last 10 times longer than standard), 8 Amp switching power supply (short protected, warranted for 3 years), KB (Penta Power) DC motor drive (short protected, warranted for 3 years), auxiliary front table Vacuum Tank (added reserve to prevent vacuum drop out), large sliding machine Panels (for easy access, with heat and noise suppression benefits), Stainless Steel safety covers (quality look with superior strength), Banner sealed Turnover Sensor (mounted above to prevent dust glue build up), clamped Gripper Arm shaft drive (for easy adjustment if required), MDS Nylon bushings added to low movement pivot points and levers (reduces wear and requires no lubrication), bearing actuated Jaw opening levers (never have to replace a lever again), extended Separator Pins, Stainless Steel Envelope Guides (slender & ergonomic for easier loading), and last but not least Stainless Steel Separator feet.
WARRANTY (parts) - 30 days on standard parts, and 1 full year on all Montronics upgrades.
PRICING - $ Call For Pricing - Financing available with good credit
